Progress PV1546 Manual do Utilizador

PV1546User ManualDishwasher

4. Carefully shake the funnel by itshandle to get the last granules inside.5. Remove the salt around the opening ofthe salt container.6. Turn the cap

2. Press the on/off button to activate theappliance.Make sure that the appliance is inprogramme selection mode.• If the salt indicator is on, fill the

Do not try to close theappliance door within 2 minutesafter AirDry automaticallyopens it, as this may causedamage to the appliance.If, afterwards, the

2. Make sure that the salt and rinse aidcontainers are full.3. Start the shortest programme with arinsing phase. Do not add detergentand do not load t

1. Turn the filter (B) counterclockwiseand remove it.2. Remove the filter (C) out of filter (B). 3. Remove the flat filter (A).4. Wash the filters.5.

• If you regularly use short durationprogrammes, these can leave depositsof grease and limescale inside theappliance. To prevent this, werecommend to

Problem and alarm code Possible cause and solutionThe appliance does not drain the wa‐ter.• The end indicator flashes 2 timesintermittently.• Acoustic

The washing and drying results are not satisfactoryProblem Possible cause and solutionPoor washing results. • Refer to "Daily use", "Hi

Problem Possible cause and solutionThere are residues of deter‐gent in the dispenser at theend of the programme.• The detergent tablet got stuck in th

Power consumption Off-mode (W) 0.501) Refer to the rating plate for other values.2) If the hot water comes from alternative source of energy, (e.g. so

CONTENTSSafety information 2Safety instructions 3Product description 5Control panel 5Programmes 6Settings 7Before first use 9Daily use 10Hints and tip

www.progress-hausgeraete.de156920170-A-232017

• Do not change the specification of this appliance.• The operating water pressure (minimum and maximum)must be between 0.5 (0.05) / 8 (0.8) bar (MPa)

• Connect the mains plug to the mainssocket only at the end of theinstallation. Make sure that there isaccess to the mains plug after theinstallation.

PRODUCT DESCRIPTION437 9 8 105611 121Upper spray arm2Lower spray arm3Filters4Rating plate5Salt container6Air vent7Rinse aid dispenser8Deterg

IndicatorsIndicator DescriptionEnd indicator.Salt indicator. It is always off while the programme operates.PROGRAMMESProgramme Degree ofsoilType of lo

SETTINGSProgramme selection mode anduser modeWhen the appliance is in programmeselection mode it is possible to set aprogramme and to enter the user m

German de‐grees (°dH)French de‐grees (°fH)mmol/l Clarke de‐greesWater softenerlevel11 - 14 19 - 25 1.9 - 2.5 13 - 17 34 - 10 7 - 18 0.7 - 1.8 5 - 12 2

During the drying phase, thedoor opens automatically andremains ajar.CAUTION! Do not try to closethe appliance door within 2minutes after automaticope