Progress PAG7530E-B Manual do Utilizador descarregar pdf (Página 26)

PNC .........................................

Serial number ...........................

Gas Connection

WARNING! The following

instructions about installation,

connection and maintenance

must be carried out by qualified

personnel in compliance with

standards and local regulations

in force.

It is necessary that the connection to the

gas mains are carried out by means of an

AGB tap. Choose fixed connections or use

a flexible pipe in AGB (stainless steel) in

compliance with the regulation in force

(NBN D 51.003). If you use flexible metallic

pipes, be careful they do not come in touch

with mobile parts or they are not squeezed.

Also be careful when the hob is put

together with an oven.

Make sure that the gas supply

pressure of the appliance obeys

the recommended values. The

adjustable connection is fixed to

the comprehensive ramp by

means of a threaded nut G 1/2".

All the components shown in

the figure have already been

assembled in the factory. The

appliance, before leaving the

factory, has been tested in order

to give you the best results.

A B C

A)

End of shaft with nut

B) Washer

C) Elbow (if needed)

Liquid gas

Use the rubber pipe holder for liquid gas.

Always engage the gasket. Then continue

with the gas connection.

The flexible pipe is prepared for apply

when:

• it can not get hot more than room

temperature, higher than 30°C;

• it is no longer than 1500 mm;

• it shows no throttles;

• it is not subject to traction or torsion;

• it does not get in touch with cutting

edges or corners;

• it can be easily examined in order to

make sure its condition.

The control of preservation of the flexible

pipe consists in checking that:

• it does not show cracks, cuts, marks of

burnings on the two ends and on its full

length;

• the material is not hardened, but shows

its correct elasticity;

• the fastening clamps are not rusted;

• expired term is not due.

If one or more defects are visible, do not

repair the pipe, but replace it.

WARNING! When installation is

complete, make sure that the

seal of each pipe fitting is

correct. Use a soapy solution,

not a flame!

Injectors replacement (only for

Belgium)

1. Remove the pan supports.

2. Remove the caps and crowns of the

burner.

3. With a socket spanner 7 remove the

injectors and replace them with the

ones which are necessary for the type

of gas you use (see table in "Technical

Information" chapter).

4. Assemble the parts, follow the same

procedure backwards.

5. Replace the rating plate (it is near the

gas supply pipe) with the one for the

new type of gas supply. You can find

26 Progress

1 2 ... 21 22 23 24 25 26 27

Comentários a estes Manuais

Sem comentários