Progress PHN1220X Manual do Utilizador descarregar pdf (Página 16)

Depth 550 mm

Oven cavity

Height 335 mm

Width 395 mm

Depth 410 mm

Oven capacity 56 l

The appliance can be combined with the

following built-in hobs and built-in glass

ceramic hobs:

Glass ceramic

hob types:

Total con-

nected

load

Supply

voltage(50

Hz)

PEM 6000 E 6000 W 230V

Glass ceramic

hob types:

Total con-

nected

load

Supply

voltage(50

Hz)

PES 6000 E 5800 W 230V

PES 6060 E 7600 W 230V

Maximum rated heating capacity:

Oven + glass ceramic hob 9450 W

Installation

Instructions for the Installer

Important!

Installation and connection must be

done in compliance with the regulations

in force. Any interventions must be

carried out when the appliance is

switched off. Only qualified service

engineers may repair the appliance

The manufacturing company disclaims

any liability if the safety measures are

not observed.

Connecting to the electrical supply

Before connecting to the electrical supply,

please make sure:

– The fuse and the domestic electrical in-

stallation must be designed for the max.

load of the appliance (see rating plate).

– The domestic electrical installation must

be equipped with a proper earth connec-

tion in accordance with the regulations in

force.

– The socket or the multi-pole off switch

must be easy to access after the appliance

has been installed.

The appliance is shipped without a mains ca-

ble, as - depending on the type of supply

available - a mains lead with a standard plug

designed for the load specified on the rating

plate is required. Insert the plug into a socket

that satisfies the regulations.

The following types of mains cable are suit-

able, taking the necessary rated cross sec-

tion into account:

H07RN-F, H05RN-F, H05RR-F, H05VVF,

H05V2V2-F (T90), H05BB-F.

If the appliance is connected without a plug,

or if the plug is not accessible, a multipole off

switch (e.g. fuses, circuit breaker) with a min-

imum gap of 3 mm between the contacts

must be installed between the appliance and

mains cable. The switch must not interrupt

the earth wire at any point. The yellow-green

earth wire should be 2-3 cm longer than all

other cables.

The connection cable must always be laid

out so that at no point does it reach 50°C

(over room temperature).

After the connection has been carried out,

the heating elements must be tested by be-

ing operated for about 3 minutes.

Terminal block

The appliance is fitted with an easily-acces-

sible 6-way terminal block, with its links al-

ready set for operation on a 400V supply with

neutral (see illustration).

In the case of a different supply voltage, the

terminal block links must be turned in line

with the schemes shown in the illustration.

The protective conductor is connected to the

terminal.

After connection, secure the cable to the ter-

minal block with strain relief.

16 progress

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 59 60

Comentários a estes Manuais

Sem comentários